edward

Man - this is turning into a damned if you do damned if you don't situation. No enough rain to fly or too much rain and we can't get there. Edward

I believe the club has some 1010, 1020, 1515 and 1530 rails available. Edward

Ken, Do you have these still available? If so I'm interested. edwardcw (at) gmail (d0t) com Edward

Geof, If you want to get together I have some e-matches, but mainly for ground testing I use nichrome wire. I also currently have a dirt backyard where you are welcome to ground test. Edward

Mike, I'll bring my Astro setup so you can use it. Edward

If anyone is planning on flying a hybrid and does NOT have their own GSE, the club does not have any carried in the trailer. PLEASE let me know by next Thursday and we can coordinate what you might ne...

Doug - glad to hear you are coming up! Will you be doing Friday night movie night again? Maybe you can bring Art out of the woodwork and to a launch 🙂 Edward

I had weight added to a 5.5" LOC Nosecone - it eventually came out during a hard landing. I used PL Premium and scuffed the plastic. After that I decided to plastic weld a plastic 1/2" thick bulkhea...

They are pre-assembled, but not stored in the casing. I should clarify that I would take the reload out of the aluminum casing and store it back in the cardboard tube it came in. The reason to do th...

I don't know how all the o-ring seals are designed, but most that I have encountered have been close to an industry standard for gland width and compression factor. Parker has an extensive manual on t...

I would take the motor apart and put it back into the container it arrived in. You don't want to have the o-rings compressed for a long time and not perform next time. If I have to take apart a motor...

Mike, Do you know if the white flowers are blooming? I remember being out on the prairie last time and it was amazing. Edward

The main difference between hybrids and solids are: Generally lower average thrust but longer burn time.Motors are longer.Center of gravity is further back.More complicated motor assembly.Lower cost p...

Same as between 38mm solids and 54mm solids. More impulse. 38mm goes from H-I (some very low J's) and 54mm goes from J-K. I do have the full SRS 38 and 54mm set that I loan out. Edward

RATT Works, Hypertech and Contrail still do. My recommendation would be RATT Works. Simple and easy to work with. Less parts and Dave knows what he is doing. If you can find a set of SRS hardware ...