edward

I'm up for that Nate 🙂 Let me know when. YOu are always welcome to mix at my place. 🙂 Edward

You made any more Everclear Nate? How about the 54mm KNER? Edward

Slicing a cylinder you should get an ellipse. In this case you'd be slicing the motor mount as your cylinder. Then you'd get your ellipse and could draw that and transfer it. 🙂 Just one way to do ...

I think somewhere I've got some LOC tubing also. If Bryan can't help you let me know. I've found Hobbytown to be very dissapointing, especially since they fired Joe. They order the same Quantum Tub...

The best one I've used is the DeWalt 12" compound sliding mitre saw. I've built numerous houses with one and it doesn't bat an eyelash. The only saw that I've used that is better is a German made ra...

Is this launch still scheduled? Anyone planning on going? Edward

A table saw works nicely. I use that and have great results. Edward

Here is a little look of what I've been working on. This was as far on the edge as I've been in terms of real research motors. Kyle and Eric got a nice sneak peek also. Edward

Even at primer bubbling...the heat doesn't penetrate. That is a very thin layer that is bonded on the best it can being an applied coating. Now if you powder coated something....then I'd be really a...

I want to know who's getting to 1200F first of all. Motors have to be kept under 392F (200C) and I'm having a hard time imagining a rocket going long enough that the entire body heats to 1200F. Some...

What gauge is the Nichrome? I had a roll of 32 and 36...PM me. Edward

I'm guessing the windmill was still in use for cattle...it did have a wagon wheel pattern of trails around it. Edward

Man! That windmill was awesome for hunting pronghorn. You'd climb up and the little guys rarely look above 6' so you'd be able to get much closer than normal - plenty close for a bow. Edward

Sugar motors are fun - there are a few people in the club that do them in snap ring hardware - I did them for a while...they are nice! Edward

You trying Wickham's AN motors? Never tried those but they sounded neat! Edward