MikeS

I hand paint everything. No sticker needed. Just wanted to make sureall was OK. Thanks everyone.

Is it OK if I paint the NCR trademark on my latest build. Thanks Mike

Most places on the internet and written material state that the center ofgravity should be no less than one tube diameter infront of the centerof pressure.... What is too far infront of center of pres...

No stop. I sometimes overthink stuff. Thanks for all the help

Here is my two cents worth. I have never flown a duel. I am just about done building a duel. My first NCR launch. I watched a large rocket take off. Big motor, Bigrush. I was soooo impressed. The roc...

I was able to launch 4 on 3/7/2007. Tested my future level 1 rocket ona G79. It went fantastic. I sure did get rid of a lot of stress.

Did Any One Fly Today? ? ?

In my instructions for my HL, It calls for:Make a mark 11" from the end of the motor mount tube along theair frame and drill the overflow tube hole using a 3/8" drill bit makingsure to extend the hole...

After long hours I am done with may EB. Now to start on the Rocket. Thanks to all the forum for the help. Could not havedone it with out Ya. 🙄

Thanks. I will put a plastic rivit in the side just to be safe.

I am building a 3" scratch. My first piston ejection. Question?? I have been reading all over the internet about piston ejectionrockets. I can not find anything about.... Will the piston drop down at...

We get Peterbilt windshields that are seperated by strips ofsemi hard rubber. I glued this rubber to the sled and recessedthe altimeter. Not real pretty but secure. I will retain the altimeterin the r...

Here are some pictures of my EB and Ejection Charge Holder. I amusing the christmas bulb style.

I have been testing the 'christmas bulb' design and itworks wonderful. Simple and very effective. Used my RRC2X on out-put test mode and tested witha rocket mock up. I am gluing the bulb assy. into a ...

Thanks 😳