Forum Replies Created
|
RE: Burn Ban alternatives Yes indeed I do John, though to be honest I don't remember the rule - it does make total sense and quite frankly, I don't want to deal with administering flights made outside sanctioned NCR launches. ... |
In forum Archives 2006-2010 |
20 years ago |
|
RE: Burn Ban alternatives That has been discussed, but no decision was made. Currently, the only valid site to fly the SSS or SSSS at is either Pawnee North or the Atlas Site. If we do get a burn ban, I will discuss with the e... |
In forum Archives 2006-2010 |
20 years ago |
|
RE: SSSS / SSS Chris, I've wrapped tubes from 3 wraps of .75 oz glass... worked just fine for F motors and I probably could have gotten away with 2 wraps. Warren |
In forum Contests |
20 years ago |
|
RE: EX June 11 You get Mike Bennett to send me their calender and James Russell to send me the Tripoli Colorado calender and I'll mix 'em in with ours and post 'em. Warren |
In forum Research/EX Motor Discussion |
20 years ago |
|
RE: Fin Jigs Why waste good money on good material. All mine were made from waste cardboard boxes. Warren |
In forum Construction Help |
20 years ago |
|
RE: Fin Jigs Bruce, First you mark your center point, then you draw out your 120 degree (or 90 degree) centerlines, then you draw your circle for the airframe, then you draw a line on either side of those centerli... |
In forum Construction Help |
20 years ago |
|
RE: Fin Jigs Most of the folks I know use cardboard ones. I have a rough set of them for HPR tube sizes made from regular corrugated box cardboard. They are easy to replace and you can lay them out perfectly with ... |
In forum Construction Help |
20 years ago |
|
RE: EX June 11 Sorry I missed ya Conway. I had planned on staying up for Sunday, but I was exhausted and the bird I'd planned on flying on Sunday had a really nice bounce from a flight to near 10K when the main didn... |
In forum Research/EX Motor Discussion |
20 years ago |
|
RE: 440cc Hypertek tank and fuel grains for sale Like I said, I have the 835cc tank. This would extend me down into the lower powered J's, give me a spare valve and 2 fuel grains... Next build session for the Uproar, bring it down with you so I can ... |
In forum Swap Meet |
20 years ago |
|
RE: 440cc Hypertek tank and fuel grains for sale I'll consider buying it. I have the 835cc tank and it sounds like you have 435cc tank. Those grains will also be a K240 with the bigger tank and the smallest orifice. Warren |
In forum Swap Meet |
20 years ago |
|
RE: SSSS / SSS On the back burner is an upgraded weather section that includes all aviation weather reports - winds at altitude, jet stream, etc. All the weather is essentially Greeley weather by the way. Warren |
In forum Contests |
20 years ago |
|
RE: SSSS / SSS Not a one... so far. I was thinking about doing it but got all caught up in flying my 4" bird. Warren |
In forum Contests |
20 years ago |
|
RE: SSSS / SSS Given the weather and strong potential for a fire ban after this launch, if you don't fly your SSS this month, you may not get a chance until Oktoberfest... I'm not fully prepared, but I may take a sh... |
In forum Contests |
20 years ago |
|
RE: Garage chemistry used to be a rite of passage for geeky kids My plan is to be out there Friday night, Saturday, Saturday night and at least until 11 or 12 on Sunday. Warren |
In forum Archives 2006-2010 |
20 years ago |
|
RE: Garage chemistry used to be a rite of passage for geeky kids Hopefully you're feeling up to snuff Conway... hoping to see you Saturday. When I met you a couple years ago, you were selling off all your rocketry stuff and I was just getting into it as a new BAR..... |
In forum Archives 2006-2010 |
20 years ago |
